Skip to content
MPSElectroLab

MPS CNC Controller MPS ElectroLab

Motion you can inspect. Boundaries you can enforce.

An open CNC control framework spanning machine configuration, planning, simulation, embedded firmware, and operator-visible execution.

View the sourceJoin the discussion

01 / Controller stack

A path from simulation to hardware.

01

Machine-aware configuration

Kinematics, limits, tooling, and machine capabilities are explicit inputs rather than hidden assumptions.

02

Observable motion

Planning, simulation, commanded state, and controller feedback are designed to remain inspectable.

03

Portable boundaries

A hardware abstraction layer and defined service contracts provide a practical path from host simulation to embedded targets.

02 / Current status

Open development with explicit safety boundaries.

The repository is the source of truth for current code, supported targets, setup instructions, open work, and release status. Review its documentation and issues before selecting it for a machine.

CNC software cannot make an unsafe machine safe. Integrators remain responsible for independent emergency stops, limits, electrical protection, guarded commissioning, machine-specific validation, and qualified operator supervision.

03 / Build with us

Inspect the implementation before the pitch.

Start with the public repository, follow the project documentation, and use the existing discussion for contribution questions. For integration or engineering support, contact MPS with the machine, controller target, and validation goal.

Discuss an integration